 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| BU1923 / BU1923F Audio ICs RDS / RBDS decoder BU1923 / BU1923F The BU1923 and BU1923F are RDS / RBDS decoders that employ a digital PLL and have a built-in anti-aliasing filter and an eight-stage BPF (switched-capacitor filter). Linear CMOS circuitry is used for low power consumption. !Applications RDS / RBDS compatible FM receivers for American and European markets, car stereos, high-fidelity stereo systems and components, and FM pagers. !Features 1) Low current. 2) Two-stage anti-aliasing filter (LPF). 3) 57kHz band-pass filter. 4) DSB demodulation (digital PLL). 5) Quality indication output for demodulated data. !Absolute maximum ratings (Ta = 25C) Parameter Power supply voltage Maximum input voltage Maximum output voltage Power dissipation Operating temperature Storage temperature Symbol VDD VMax. IMax. Pd Topr Tstg Limits -0.3~+7.0 -0.3~VDD+0.3 4.0 350 -40~+85 -55~+125 Unit V V mA mW C C Conditions VDD1 VDD2 All input pins All output pins - - - Reduced by 3.5mW for each increase in Ta of 1C over 25C. !Recommended operating conditions (Ta = 25C) Parameter Power supply voltage Symbol VDD1 VDD2 Min. 4.5 4.5 Typ. - - Max. 5.5 5.5 Unit V V BU1923 / BU1923F Audio ICs !Block diagram 560p CMP MUX 270p (4) 100k VSS3 (7) (8) 120k 100k 8th Switched capacitor filter comparator Vref (3) anti-aliasing filter 2.2F VDD1 (5) Analog Power supply (16) RCLK 1 (1) QUAL VSS1 (6) 1 VDD2 (12) Digital Power supply (11) PLL 57kHZ RDS/ARI PLL 1187.5Hz Bi-phase decoder Differential decoder (2) RDATA 2 VSS2 Reference clock (13) XI 4.332MHZ (14) XO (10) Measurement circuit (9) T2 T1 33pF 33pF 3 3 1: VDD1 and VDD2 are separated within the IC. 2: Have VDD2 (digital power supply) of a sufficiently low impedance. 3: Match the capacitor constants with the crystal manufacturer. RCLK (N.C.) VDD2 VSS2 XO T1 16 15 14 13 12 11 10 1 2 3 4 5 6 7 8 VSS1 VSS3 QUAL RDATA MUX CMP VDD1 Vref T2 9 XI BU1923 / BU1923F Audio ICs !Pin descriptions Pin No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Symbol QUAL RDATA Vref MUX VDD1 VSS1 VSS3 CMP T2 T1 VDD2 VSS2 XI XO (N.C.) RCLK Crystal oscillator - Demodulator clock Digital power supply 4.5V to 5.5V Connects to 4.332MHz oscillator (refer to input/output circuits) - 1187.5Hz clock (refer to the timing diagram) Test input Open or connected to ground Type B - Analog power supply 4.5V to 5.5V GND Comparator input - C-junction (refer to input/output circuits ) Pin name Functions Input/Output type Type C - Type E Type D - - Type D Demodulator quality Good data: High, bad data : Low Demodulator data Reference voltage Input Refer to output data timing 1/2 VDD1 (refer to input/output circuits) Composite signal input (refer to input/output circuits) Type A - Type C !Input / Output circuits Type A Type B Type C 10M Type D + Type E + - BU1923 / BU1923F Audio ICs !Electrical characteristics (unless otherwise noted, Ta = 25C, VDD1 = VDD2 = 5.0V, VSS1 = VSS2 = 0.0V) Parameter Operating current Reference voltage Input current 1 Output current 1 Input current 2 Output current 2 Output high level voltage 1 Output low level voltage 1 Filter block Center frequency Gain Attenuation 1 Attenuation 2 Attenuation 3 S / N ratio Maximum input level Demodulator RDS detector sensitivity RDS input level ARI detector sensitivity Data rate Clock transient vs. data Not designed for radiation resistance. Symbol IDD Vref IIN1 IOUT1 IIN2 IOUT2 VOH1 VOL1 Min. - - - - - - VDD2 -1.0 - Typ. 4.5 1/2VDD1 - - - - VDD2 -0.3 0.2 Max. 7.0 - 1.0 1.0 1.0 1.0 - 1.0 Unit mA V A A A A V V IDD1+IDD2 Pin 3 MUX MUX XI XI Conditions VIN=VDD1 VIN=VDD1 VIN=VDD2 VIN=VDD2 IO=-1.0mA IO=1.0mA RCLK RDATA QUAL RCLK RDATA QUAL FC GA ATT1 ATT2 ATT3 SN VMAX1 56.5 23 18 65 35 30 - - - - - - 57.0 26 22 80 50 40 - 0.5 - 1.5 1187.5 4.3 57.5 29 - - - - 500 kHz dB dB dB dB dB mVrms F=57.0kHz 57kHz4kHz 38kHz 67kHz 57kHz VIN=3mVrms SRDS MRDS SARI DRATE CT 1.0 300 3.0 - - mVrms mVrms mVrms Hz s !Output data timing RCLK RDATA T1 T1=T2=4.3s T5 T1 T3 T3=T4=421s T4 T5=T6=416.7s T2 T6 T2 The clock (RCLK) frequency is 1187.5Hz. Depending on the state of the internal PLL clock, the data (RDATA) is replaced in synchronous with either the rising or falling edge of the clock. To read the data, you may choose either the rising or falling edge of the clock as the reference. The data is valid for 416.7s. after the reference clock edge. QUAL pin operation : Indicates the quality of the demodulated data. (1) Good data : HI (2) Poor data : LO BU1923 / BU1923F Audio ICs !Electrical characteristic curves 30 20 10 FILTER GAIN : G (dB) 0 -10 -20 -30 -40 -50 -60 -70 10 20 30 40 50 60 70 80 90 100 FREQUENCY : f (kHz) Fig.1 Band-pass filter characteristics !External dimensions (Units : mm) BU1923 BU1923F 19.40.3 16 9 6.50.3 10.00.2 16 6.20.3 4.40.2 9 1 0.51Min. 3.20.2 4.250.3 8 7.62 1 0.30.1 8 1.50.1 2.54 0.50.1 0~15 0.11 1.27 0.40.1 0.3Min. 0.15 DIP16 SOP16 0.150.1 |
Price & Availability of BU1923FNBSP
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |